CAD-Technologies
xmas_line

Frequently asked questions:

Q. - Is there a mailing list devoted to Imagine?

A. - Yes. Please go to the following address to join the Imagine Mailing List.
From this site, it is also possible to search the archives for information,
tutorials, tips, links to users WEB sites and galleries etc.

Submissions to the list may be sent to:
IMAGINE@MAELSTROM.STJOHNS.EDU
Please add at least one of the following text items to the start of the subject header:
ADMIN, AMIGA, AREXX, CHAT, CONTEST, IMPULSE, OTHER, QUEST, or WEB.


Q. - Imagine doesnt work!

A. - If your Amiga matches, or exceeds the minimum requirements, then this should
not happen. Please try removing all "patches" from your Startup-sequence &
User-Startup files, and from your WBstartup drawer. If the problem still persists,
then send an email to the support address, which can be found in the contact page.
Imagine has been tested, and works fine on almost any Amiga configuration supported.


Q. - I've been using textures, but some of them dont work!

A. - All textures have a mix/morph value which can be set in the object attributes
window. Setting it to "0" will turn off the texture, while setting it to "1" will show the
texture fully. (a value of "0.5" fill show the texture at 50% strength)
If the texture does not appear to work, then make sure that the mix/morph value is not
set to "0".





Send comments or suggestions about this WEB site to webmaster@cadtech.demon.co.uk.
Copyright © 1998 CAD Technologies. All rights reserved.
All specifications subject to change without notice.
Other products and companies referred to herein are trademarks or registered trademarks of their respective companies or trademark holders.